Skip to main content
Engineer - Tier IV Level Support Responsibilities Provide Tier IV Level support and assist with any issues that may arise in your area or on the projects you are working on. Engineering & Design Read, interpret, review, and redline P&IDs, Electrical and Instrumentation Schematics. Participate in design review of all projects. Lead an automation (controls) focused PHA. Take complete ownership of Tagging, Symbols and References for all projects. Define key equipment design parameters such as design/operating pressure and design/operating temperature. Select hardware components and ensure instrumentation suitability for the selected parameters, ranges, alarm set points, and trip set points. Define control panel interfaces signals to/from main control room and field instruments, including hardwired and serial linked signals. Configure control loops between the instruments and equipment. Ensure project requirements, expectations, or operational points are within WIMS operating philosophies & standards. Authorize and ensure consistency between documents such as instrument index, control philosophy, programs, and C&E. Review P&IDs to check consistency with ESD philosophy. PLC Programming Write logic for SCP and ESD PLCs, transmitters, devices, compressors, Scada packs, generators, vent fans, gas coolers, gas control, power monitor, air compressors, ESD, fire and gas detectors. Set up all devices and input IP addresses. Order and procure modules and devices for the project. Request IP address allocations from IT. Conduct gas control data tests, point-to-point and final data review. HMI Automation Create screens and alarms for SCP and ESD PLCs, transmitters, devices, compressors, Scada packs, generators, vent fans, gas coolers, station control, daily reports, trending, ESD, fire, and gas. Order HMI machine for Wonderware. Order Wonderware license. Fat Testing Travel and conduct factory acceptance tests of control buildings, control panels, and motor control centers. Maintain, test, verify cause and effect, and IO lists. Commissioning Travel and commission the entire station controls and automation system. Test and commission every device tied into the control system as detailed in PLC Programming and HMI Automation. Test and commission Scada. Experience 8-10 years of experience preferred. 5 years of experience minimum. Prior oil and gas experience required.

Also on the board Same function, level within a rung

Level

Senior

Location

Houston, TX

Occupation

Engineering Technologists and Technicians, Except Drafters, All Other

Industry

Engineering Services

Posted

yesterday

Apply for this role (opens in a new tab)